Filter
Top Products
M12
15
2
WARNING LABEL IDENTIFICATION
FAILURE TO OBSERVE THE FOLLOWING WARNINGS COULD RESULT IN INJURY.
Always wear eye protection
when operating or perform-
ing maintenance on this
tool.
WARNING
WARNING
Always wear hearing
protection when operating
this tool.
Always turn off the air sup-
ply and disconnect the air
supply hose before install-
ing, removing or adjusting
any accessory on this tool,
or before performing any
maintenance on this tool.
WARNING
Air powered tools can vibrate
in use. Vibration, repetitive
motions or uncomfortable po-
sitions may be harmful to your
hands and arms. Stop using
any tool if discomfort, tingling
feeling or pain occurs. Seek
medical advice before resum-
ing use.
WARNING
Do not carry the tool by
the hose.
WARNING
WARNING
Do not use damaged, frayed
or deteriorated air hoses
and fittings.
WARNING
Keep body stance balanced
and firm. Do not overreach
when operating this tool.
WARNING
Operate at 90 psig (6.2 bar/
620 kPa) Maximum air pressure.
90 psig
(6.2bar/620kPa)
WARNING
Read the manual before
operating this tool.
Operate at 90 psig/6.2 bar max.
PN 48176–1 LABEL
(NON–EU MODELS)
This label must appear on the tool at all times. If it is lost or
damaged, a replacement label is available at no cost.
PN 49883 LABEL
(–EU MODELS)
WARNING
SANDER SPECIFIC WARNINGS
• Use only a sanding pad, buffing wheel or
polishing bonnet with these tools. Do not use
any grinding wheel, bur or metal removing
accessory other than a sanding pad with
these tools. Never use an accessory having a
maximum operating speed less than the free
speed of the Sander in which it is being used.
• These Sanders will operate at the free speed
specified on the nameplate if the air supply
line furnishes 90 psig (6.2 bar/620 kPa) air
pressure at the tool. Operation at higher air
pressure will result in excessive speed.
• Do not operate this Sander away from the
work surface.
• Check for excessive speed and vibration
before operating.
• Do not use this tool if actual free speed
exceeds the nameplate rpm.
• Never exceed the rated rpm of tool.
• Whenever the Angle Head is installed or
repositioned, the Throttle Lever must be
positioned so that reaction torque will not
tend to retain the throttle in the “ON” position.
• Repeated prolonged operator exposure to
vibrations which may be generated in the use
of certain hand–held tools may produce
Raynaud’s phenomenon, commonly referred
to as Whitefinger disease. The phenomenon
produces numbness and burning sensations
in the hand and may cause circulation and
nerve damage as well as tissue necrosis.
Repetitive users of hand–held tool who
experience vibrations should closely monitor
duration of use and their physical condition.
• When using a pad having a shank, insert the
shank to full depth in the collet. When using a
pad on a threaded arbor, make certain the
flange nut is tightened securely. Check the
tightness of the collet nut or flange nut before
operating a Sander to make certain it will not
loosen during operation.