Filter
Top Products
EN-3 04581922_ed4
EN
HOW TO USE THIS MANUAL
This manual is divided into sections describing the steps to be
taken to congure the Expert Torque Wrench for use in measuring
and recording torque values.
Section 1 is an introduction to the Expert Torque Wrench.
Section 2 describes the controls and features.
Section 3 describes how to congure and use the Expert Torque
Wrench.
The following conventions are adopted throughout this manual:
Keys to be pressed will be shown as the key legend - for example
ENTER. Information displayed on the LCD screen will be
shown within quotation marks i.e. ‘Select Fault’ or displayed as an
actual screenshot.
PACKING LIST
The following items are supplied with the basic Expert Torque
Wrench unit:
1 x Expert Electronic Torque Wrench 1 x Aluminum Carry Case
1 x Battery Pack 1 x Calibration Certicate
1 x Square Drive Adapter 1 x User Manual
1 x Battery Charger 1 x RS232 cable
Care & Storage
This unit is designed for indoor use only.
Operating temperature range 5-40 degrees C
Storage temperature range 0-50 degrees C
The membrane keypad may be wiped clean with a soft damp cloth.
The unit is not waterproofed and spillages should be avoided.
THIS UNIT CONTAINS NO USER SERVICEABLE PARTS. ONLY QUALI-
FIED SERVICE PERSONNEL SHOULD REPLACE OR FIT PARTS.
Batteries
Expert Torque Wrench requires ETW-EBP Ingersoll Rand supplied
rechargeable cell pack (battery life - typically 8 hours of continuous
use).
OVERVIEW
Expert Torque Wrench’s range of software features can be
individually programmed to give a conguration most suited to
the requirements - from a simple torque wrench to an extensive
tightening control unit.
The Expert Torque Wrench features four measurement modes
that monitor the torque and angle of a fastening operation.
Measurements can be taken for peak values or in real time. The
wrench can even be programmed to indicate when a fastener has
reached a target torque, target angle, or yield point.
The Expert Torque Wrench is designed to be point of load
insensitive, which means that the operator can be assured of
correct measurement however the wrench is held and torque is
applied - particularly useful in limited access situations.
Expert Torque Wrench is supplied with a dovetail (Sturtevant
Richmont®) interchangeable head tting, giving a wide range of
head attachments to meet the assembly requirements.
Data from the Expert Torque Wrench can either be printed or
downloaded to a PC using the supplied RS232 cable.
Note: The Expert Torque Wrench cable has a 5 pin round
connector to the wrench. This means the previous 4 pin cables for
earlier Expert Torque Wrench models cannot be used.
PARTS & ACCESSORIES
ETW - EBC Battery Charger
ETW - EBP Rechargeable Battery Pack
ETW - ECC Carry Case
ETW - ED9B PC Cable
ETW - CONNECT PC Comms Software
ETW - E25 - R04 Ratchet Drive 1/4” Square
ETW - E75 - R06 Ratchet Drive 3/8” Square
ETW - E180 - R08 Ratchet Drive 1/2” Square
04581922 User Manual
45517257 Safety Information
SECTION 1 - INTRODUCTION