Filter
Top Products
M10
180
3
SANDER/POLISHER SPECIFIC WARNINGS
• These Sanders and Polishers will operate at the free
speed specified on the nameplate if the air supply
line furnishes 90 psig (6.2 bar/620 kPa) air pressure
at the tool. Operation at higher air pressure will
result in excessive speed.
• Use only a sanding pad, buffing wheel or polishing
bonnet with these tools. Do not use any grinding
wheel, bur or metal removing accessory other than
a sanding pad with these tools. Never use an
accessory having a maximum operating speed less
than the free speed of the Sander or Polisher in
which it is being used.
• When using a pad on a threaded arbor, make
certain the flange nut is tightened securely. Check
the tightness of the flange nut before operating a
Sander to make certain it will not loosen during
operation.
WARNING: Incorrect combinations of grinding wheel, wheel guard and tool speed could result in injury.
Correct combinations are specified below:
Guard Part Number
Wheel Type Wheel Diameter
in. (mm)
Maximum Wheel
Thickness
in. (mm)
Maximum Speed
rpm
77A–106–7 27, 28 7 (178) 1/4 (6.4) 7,500
77A–106–9 27, 28 7 (178) 1/4 (6.4) 6,000
PLACING TOOL IN SERVICE
LUBRICATION
IRAX No. 50P IRAX No. 68 1LB
Always use an air line lubricator with these tools.
We recommend the following Filter–Lubricator–Regulator
Unit:
For USA – No. C18–03–FKG0–28
Before starting the tool, unless the air line lubricator is
used, detach the air hose and inject about 2.5 cc of IRAX
No. 50P Oil into the air inlet.
After each eight hours of operation, replenish the oil
supply. Remove the Oil Chamber Plug (7) from the
Throttle Handle (1) and fill the chamber.
After each forty–eight hours of operation, inject about
5 cc of IRAX No. 68 1LB Grease into each Grease
Fitting (44).
MAIN LINES 3 TIMES
AIR TOOL INLET SIZE
TO
AIR
SYSTEM
TO
AIR
TOOL
LUBRICATOR
REGULATOR
FILTER
BRANCH LINE 2 TIMES
AIR TOOL INLET SIZE
DRAIN REGULARLY
COMPRESSOR
(Dwg. TPD905–1)