Filter
Top Products
10
WARNING
DO NOT run unit without filter.
Avoid operating this product in a dusty environment
which could cause premature compressor wear.
SETUP
1. Place the device on a table so that the controls can be reached
when seated.
2. Open the storage compartment door by lifting up the latch with
your thumb and pulling out with your fingers.
3. Remove nebulizer, nebulizer mouthpiece, and air tubing from the
storage compartment.
4. Secure one end of the tubing to the compressor air outlet
(FIGURE 1).
5. Connect the other end to the nebulizer.
WARNING
In the case of high humidity, condensation may form
inside the internal tubing. Run the unit for two (2) minutes
before connecting the nebulizer to the tubing.
6. Add liquid medication to the nebulizer according to your
physicians prescription (FIGURE 2).
OPERATION
FIGURE 1 - LOCATION OF COMPRESSOR AIR OUTLET
Thumb Latch
Compressor Air Outlet for connecting
Nebulizer Air Tubing
Power Switch