Filter
Top Products
11
WARNING
Before plugging in the line cord, make sure that the power
switch is in the OFF (O) position.
7. Remove the line cord from the storage bin in the rear of the unit
(FIGURE 3).
8. Plug into a 115V/60Hz wall outlet.
9. Insert the nebulizer mouthpiece into the top of the nebulizer.
NOTE: Before attempting to start a cold unit, let the unit reach room
temperature in a heated area.
10. Press the power switch ON ( I ) to start the compressor.
11. Place mouthpiece between your teeth and close your mouth (FIGURE 4).
12. As aerosol begins to flow, inhale deeply, slowly, and hold breath for
10 seconds. Then exhale slowly through the mouthpiece.
NOTE: If you need to rest during a treatment, place the nebulizer in the round
holder located within the handle opening. (Refer to Features Section in this manual.)
NOTE: Unit may be operated with the storage compartment door closed. Route
nebulizer air tubing through side opening in storage compartment door.
NOTE: Before storing supplies between treatments, clean and dry nebulizer.
(Refer to Maintenance Section in this manual.) Tighten caps on medication jars.
OPERATION
FIGURE 2 - ADDING
LIQUID MEDICATION
TO THE NEBULIZER
FIGURE 3 - LINE CORD
LOCATION
FIGURE 4 - USING THE NEBULIZER