Filter
Top Products
9
WARNING
Read and understand the entire contents of
this manual before attempting assembly or
operation!
Failure to comply may cause serious injury!
Contents of the Shipping Containers
1. Lathe
1. Tailstock
1. Headstock
1. Face Plate
1. Tool Rest Body
1. Accessory Package
1. Owner’s Manual and Warranty Card
Accessory Package Box
1. Live Center
1. Spur Center
1. Index Pin
1. Wrench
1. Drift Rod
1. Tool Rest
1. Tool Rest Extension
Unpacking and Clean-Up
1. Remove the shipping container. Do not
discard any shipping material until the lathe
is set up and running properly.
2. Remove tailstock, tool rest and headstock
before lifting; see “Adjusting Clamping
Mechanism” on Page 20 on how to remove
the tailstock, headstock or tool rest.
3. Remove hex cap bolts from skid bottom and
lift the lathe bed, with the help from another
person, off the skid and into position.
4. Mount the lathe to a solid workbench or refer
to the “Stand Legs (optional assembly)”
instructions, on page 10, if you have
purchased the stand legs.
5. Clean all rust protected surfaces with a
cleaner degreaser. Clean under the
headstock, tailstock and tool rest body.
6. Reinstall headstock, tool rest and tailstock
unless you are mounting to optional legs.
Assembly
1. Secure tool rest (A, Fig. 1) to tool rest body
(B, Fig. 1) by tightening handle (C, Fig. 1).
Note: For some turning applications, you
may need to assemble the tool rest
extension between the tool rest body and
tool rest.
708358K Shown with optional legs
Contents of Accessory Package