Filter
Top Products
10
Connector Housing
5. Attach three support legs (A, Fig. 4) to the base
using six M8 x 16 hex cap bolts and six M8 flat
washers (B, Fig. 4). Hand-tighten only at this time.
6. Install the housing (A, Fig. 5) to two support
legs (B, Fig. 5) using four M8 x 16 hex cap bolts,
eight M8 flat washers, and four M8 hex nuts (C,
Fig. 5). Be sure hose opening faces fan housing.
Note: For models DC-1200BK or DC-1200-3BK
only – Before attaching third support bracket place
the hanger bracket (D, Fig.5) between the support
bracket and the housing.
7. Tighten all nuts and bolts at this time with a 13mm
wrench.
Hose
Referring to Figure 6:
8. Attach the hose (B) between the fan housing (A)
and the impeller housing (D) with two clamps (C).
Tighten the clamps to secure the hose.
This completes the Base Unit assembly. If you
purchased the DC-1200BK or DC-1200-3BK Dust
Collector (filter bag version), continue on the following
page. If you purchased the DC-1200CK or DC-1200-
3CK Dust Collector (canister filter version), proceed to
Canister Kit Assembly section on page 12.
Figure 4
Figure 5
Figure 6