Jet Tools DC-1100A Dust Collector User Manual


 
9
Assembly
Base
1. Install four casters to the under side of the base as
pictured in Fig. 2.
2. Thread the hex nut (B, Fig. 1) onto the caster
shaft. Then slide the lock washer (A, Fig. 1) over
the caster shaft. Thread the caster shaft into the
threaded hole on the underside of the base, turn
until snug. Tighten the nut (B, Fig. 1) against the
base with a 14mm wrench. This will give the
caster proper clearance.
Motor and Fan Assembly
3. Place the base with casters on the ground. Attach
the motor and fan assembly (A, Fig. 2) to the base
using four M8 x 16 hex cap screws, four M8 flat
washers (B, Fig. 2), and a 13mm wrench.
The dust collector must not be
connected to the power source during assembly.
Failure to comply may result in serious injury!
4. Attach inlet guard (A, Fig. 3) to fan housing using
eight M6 x 12 pan head screws (B, Fig. 3). Press
the inlet ports (C, Fig. 3) onto the inlet guard until it
snaps into place.
To reduce the risk of injury from
moving parts, always keep inlet port covered with
the caps provided, if they are not connected to a
hose. Failure to comply may result in serious
injury!
Figure 1
Figure 2
Figure 3