Filter
Top Products
9
Stand Assembly (optional accessory)
1. Match the hole patterns in the stand legs
with the hole patterns in the stand supports.
Mount the legs to the outside of the supports
using sixteen M8x16 carriage bolts and
sixteen M8 flange lock nuts, figure 1. Do
not tighten until the stand has been
assembled and is sitting level on the floor.
2. Bolt the sander to the stand with four
M10x40 hex cap bolts, eight M10 flat
washers, four M10 lock washers and four
M10 hex nuts
Sander Assembly
1. Mount the sander to JET’s open stand with
four M10x40 hex head bolts, eight M10 flat
washers, four lock washers, and four hex
nuts. Tighten the nuts to secure the sander
to the stand.
Note: If you are going to use the sander as
a benchtop unit mount the sander to the
workbench with the supplied bolts.
2. Unscrew the knob (A, Fig. 2), remove the
washer (B, Fig. 2) and the trunnion holder
(C, Fig. 2). Repeat for opposite side.
3. Lift the table (D, Fig. 2) into position and set
on top of the split pins and threaded shaft.
4. Reinstall the trunnion holder, washer and
knob. Repeat for opposite side.
5. Make sure the trunnion and trunnion holder
engage and tighten the knob.
6. Place the gasket (E, Fig. 3) against the
sander base and mount the inlet port (F, Fig.
3) to the sander with four M6x16 hex cap
bolts (G, Fig. 3).
Warning
Avoid kickback by sanding in accordance
with directional arrow. Sand on downward
side of disc. Sanding on the upward side
could cause the workpiece to fly up causing
injury! Failure to comply may cause serious
injury!