Filter
Top Products
14
Fence Stop Adjustments
Periodically check the 90° and 45° backward
(135°) tilt accuracy of the fence with an angle
measuring device, such as an adjustable square or
machinist’s protractor.
90º Fence Adjustment
Referring to Figure 13:
The 90º stop is controlled by the stop bolt (E) and
the stop block (C).
1. Set the infeed table to approximately the same
height as the outfeed table.
2. Move the fence by releasing lock handle (D)
and pushing the fence assembly until it
overlaps the tables (B).
3. Tighten lock handle (D).
4. Adjust the fence to a 90º angle by releasing
lock handle (J), pulling up on the fence handle
(A), and tightening the lock handle (J).
Note: The stop bolt (E) should be resting
against the stop plate (C).
5. Place an angle measuring device on the table
and against the fence to confirm a 90º setting
(A, Fig. 14).
6. If the fence is not square to the table, release
the lock handle (J), loosen the hex nut (F), and
turn the stop bolt (E) until the fence is square
to the table.
7. Tighten the lock nut (F) to retain the setting.
Tighten the lock handle (J).
45º Fence Backward Stop Adjustment
Referring to Figure 15:
The 45º fence backward stop (fence positioned
away from the operator) is controlled by the stop
bolt (E).
1. Loosen the lock handle (A). Move the stop
plate (D) out of the way and position the fence
at the 135º angle. Make sure the fence sits
against the stop bolt. (E).
2. Tighten the lock handle (A)
3. Place an angle measuring device on the table
and against the fence to confirm a 135º setting
(A. Fig. 16).
4. To adjust, loosen the lock nut (F), turn the stop
bolt (E) until a 135º angle is obtained.
5. Tighten the lock nut (F).
Figure 13
Figure 14
Figure 15
Figure 16