Filter
Top Products
9
Controls
Longitudinal Hand Wheels: (X-axis) (A, Fig. 6)
Located on either side of the table. Moves table
side to side.
Cross Feed Hand Wheel: (Y-axis) (B, Fig. 6)
Located on the front of the base. Moves table
toward, or away from the column.
Adjustable Table Stops: (C,Fig.6)
Located on table front. Adjust to stop table at
any setting along the longitudinal axis.
Table Locks: (D&E,Fig.6)
Longitudinal table locks are located on front of
the table. Cross-feed table locks are located on
the right side under the table. Turn clockwise to
lock.
Depth Stop:
JMD-15: (K, Fig. 8) located on the left side. Set
nuts for desired depth stop.
JMD-18: (F, Fig. 7) located in the front. Push in
the button on the front of the quick adjust stop
and move to desired position.
JMD-18PFN: Set the depth stop on the power
down feed assembly to desired depth for
repetitive drilling to the same depth, see “Power
Feed Operation” on page 12.
Downfeed Handles: (G,Fig.7)
Located on the right side of the head casting.
Counter-clockwise movement advances the quill
toward the table. Return spring retracts the
handles. Note: theknob(I,Fig.7)mustbe
loose for the downfeed handles to work.
Fine Feed Hand Wheel: (H,Fig.7)
Located on the front of the head casting. To
activate, tighten the knob (I Fig. 7) and turn the
power feed speed range dial (J, Fig. 7) to zero.