Filter
Top Products
8
Unpacking
1. Remove contents from the shipping box.
2. Inspect contents for shipping damage and
report damage, if any, to your distributor.
3. Be sure to keep the box and packing
material should you need to pack the lathe
for moving.
4. Do not clean the lathe with anything other
than a damp cloth or a mild solvent. Use of
heavy solvents, paint thinner, gasoline, etc.
will damage painted surfaces.
Contents of the Shipping Carton:
JML-1014
I
JWL-1220
1 – Lathe 1 – Lathe
1 – 6” Tool rest 2 – Tool rests (6”,10”)
1 – Face plate 1 – Face plate
1 – Drift rod 1 – Drift rod
1 – Live center 1 – Live center
1 – Spur center 1 – Spur center
1 – Safety goggles 1 – Safety goggles
1 – Owner’s manual 1 – Tool caddy
1 – Warranty card 1 – Work lamp (bulb
1 – 3mm hex wrench not included)
1 – 5mm hex wrench 1 – Owner’s manual
1 – Warranty card
1 – 3mm hex wrench
1 – 5mm hex wrench
Assembly
The JML-1014I is fully assembled and comes
ready to use right out of the box. However, it is a
good practice to thoroughly check the machine
for loose fasteners, handles, etc. before use.
The JWL-1220 requires minor assembly: Install
the tool caddy using the two pan head screws,
as shown in Figure 1. The JWL-1220 is provided
with a lifting handle on each end. These can be
pushed in when not in use.
If desired, the lathe can be bolted to a work
table or stand by removing the rubber feet and
inserting screws through the holes in the base.
IMPORTANT: The table or stand should have
an opening directly beneath the motor to prevent
build-up of shavings around the motor’s fan
housing.
A stand specifically made for the lathe is
available from Walter Meier (Manufacturing) Inc.
See stock numbers on page 6 for ordering.
Figure 1 – Model JWL-1220 only