Filter
Top Products
6 3/8-Inch Reversible Drill Operator's Manual
AVOID PROLONGED EXPOSURE TO VIBRATION
Pneumatic tools can vibrate during use. Prolonged exposure
to vibration or very repetitive hand and arm movements, can
cause injury. Stop using any tool if discomfort, tingling feeling
or pain occurs. You should consult your physician before
resuming use of the tool.
90 PSIG MAXIMUM
Designed to operate at an air pressure of 90 pounds per square
inch gauge pressure (90 PSIG) maximum, at the tool. Use of
higher air pressure can, and may cause injury. Also use of
higher air pressure places the internal components under loads
and stresses they were not designed for, causing premature
tool failure.
NOTE: The air supply should be clean and dry, preferably
lubricated. For best results drain the moisture from your
compressor daily.
USE ACCESSORIES RATED AT OR ABOVE THE TOOL RPM
RATING
Always disconnect tool from air supply before changing
accessories. Never hold work in hands, lap or against other
parts of the body. Secure all work with clamps or a vice so that
both hands are free to operate tool. Keep proper footing at all
times. Verify tool direction before starting. Do not change
direction of tool while tool is running. Do not force tool, allow
drill to work at designed pace.
WARNING
CAUTION