John Deere ET-3505-J Drill User Manual


 
1/2-Inch and 3/8-Inch Drill Operator's Manual 5
KEEP YOUR WORK AREA CLEAN AND WELL
LIT. Cluttered benches and dark areas invite
accidents.
DO NOT OPERATE POWER TOOLS IN EXPLO-
SIVE ATMOSPHERES, SUCH AS IN THE PRES-
ENCE OF FLAMMABLE LIQUIDS, GASES, OR
DUST. Power tools create sparks which may ignite
the dust of fumes.
KEEP BYSTANDERS CHILDREN, AND VISITORS
AWAY WHILE OPERATING A POWER TOOL.
Distractions can cause you to lose control.
ELECTRICAL SAFETY
DOUBLE INSULATED TOOLS ARE EQUIPPED
WITH A POLARIZED PLUG (ONE BLADE IS
WIDER THAN THE OTHER.) THIS PLUG WILL FIT
IN A POLARIZED OUTLET ONLY ONE WAY. IF
THE PLUG DOES NOT FIT FULLY IN THE
OUTLET, REVERSE THE PLUG. IF IT STILL
DOES NOT FIT, CONTACT A QUALIFIED
ELECTRICIAN TO INSTALL A POLARIZED
OUTLET. DO NOT CHANGE THE PLUG IN ANY
WAY. Double Insulation eliminates the need for
the three wire grounded power cord and grounded
power supply system.
AVOID BODY CONTACT WITH GROUNDED
SURFACES SUCH AS PIPES, RADIATORS,
RANGES AND REFRIGERATORS. There is an
increased risk of electric shock if your body is
grounded.
DO NOT EXPOSE POWER TOOLS TO RAIN OR
WET CONDITIONS. Water entering a power tool
will increase the risk of electric shock.
DO NOT ABUSE THE CORD. NEVER USE THE
CORD TO CARRY THE TOOLS OR PULL THE
PLUG FROM A RECEPTACLE. KEEP CORD
AWAY FROM HEAT, OIL, SHARP EDGES OR
MOVING PARTS. REPLACE DAMAGED CORDS
IMMEDIATELY. Damaged cords increase the risk of
electric shock.
WHEN OPERATING A POWER TOOL OUTSIDE,
USE AN OUTDOOR EXTENSION CORD MARKED
“W-A” OR “W”. These cords are rated for outdoor
use and reduce the risk of electric shock.
WARNING