Filter
Top Products
8 1/2-Inch and 3/8-Inch Drill Operator's Manual
SAVE THESE INSTRUCTIONS AND MAKE THEM AVAILABLE TO
OTHER USERS AND OWNERS OF THIS TOOL!
CAUTION
SPECIFIC SAFETY RULES AND SYMBOLS (CONTINUED)
19. DO NOT WIPE PLASTIC PARTS WITH SOLVENT.
Solvents such as gasoline, thinner benzine, carbon tetrachloride, and alcohol may
damage and crack plastic parts. Do not wipe them with such solvents.
Wipe plastic parts with a soft cloth lightly dampened with soapy water and dry
thoroughly.
20. ALWAYS wear eye protection that meets the requirement of the latest revision of
ANSI Standard Z87.1.
21. ALWAYS be careful with buried objects such as under
ground wiring. Touching active wiring or electric cable
with this tool, may cause an electric shock. Confirm if
there are any buried objects such as electric cable
within the wall, floor or ceiling where you are going
to operate here after.
22. Definitions for symbols used on this tool
Volts = V
Hertz = Hz
Amperes = A
No load speed = n
o
Watt = W
Class II Construction =
Revolutions per minute = ---/min
WARNING
DOUBLE INSULATION FOR SAFER OPERATION
To ensure safer operation of this power tool, JOHN DEERE has adopted a double
insulation design. “Double insulation “ means that two physically separated insulation
systems have been used to insulate the electrically conductive materials connected to
the power supply from the outer frame handled by the operator. Therefore, either the
symbol “ ” or the words “Double insulation” appear on the power tool or on the
nameplate.
Although this system has no external grounding, you must still follow the normal
electrical safety precautions given in this Instruction Manual, including not using the
power tool in wet environments.
To keep the double insulation system effective, follow these precautions:
a. Only JOHN DEERE AUTHORIZED DEALER should disassemble or assemble
this power tool, and only genuine JOHN DEERE replacement parts should be
installed.
b. Clean the exterior of the power tool only with a soft cloth moistened with soapy
water, and dry thoroughly.
Never use solvents, gasoline or thinners on plastic components; otherwise the plastic
may dissolve.
SERVICE
TOOL SERVICE MUST BE PERFORMED ONLY BY A JOHN DEERE AUTHORIZED
SERVICE CENTER. Service or maintenance performed by unqualified personnel could
result in a risk of injury.
WHEN SERVICING A TOOL, USE ONLY IDENTICAL REPLACEMENT PARTS.
FOLLOW INSTRUCTIONS IN THE MAINTENANCE SECTION OF THIS MANUAL.
Use of unauthorized parts or failure to follow Maintenance Instruction may create a risk
of electric shock or injury.