Filter
Top Products
Cordless Impact Wrench Operator's Manual 15
Operation
PRE-OPERATION:
Check the work area to make sure that it is clear of debris and
clutter. Clear the area of unnecessary personnel. Ensure that
lighting and ventilation is adequate.
OPERATION:
Using the light equipped hook:
CAUTION: DO NOT ATTACH THE TIP TOOL TO
THE TOOL MAIN UNIT WHEN
CARRYING THE TOOL MAIN UNIT WITH
THE LIGHT EQUIPPED HOOK
SUSPENDED FROM A WAIST BELT.
SUCH ACTION COULD RESULT IN
INJURY.
The light equipped hook has the following two functions:
a. It can be used as a hook for suspending from a waist
belt when required by the nature of the work.
b. It can be used as an auxiliary light for such
operations as tightening screws in a dark place.
The hook can be installed on the right or left side and the
angle can be adjusted in 5 steps between 0° and 80°.
1. Operating the hook
a. Pull out the hook toward you in the direction of arrow
(A) and turn in the direction of arrow (B). (Fig. 5)
b. The angle can be adjusted in 5 steps (0°, 20°, 40°,
60°, 80°).
Adjust the angle of the hook to the desired position for
use.
2. Switching the hook position:
CAUTION: IF THE TOOL FALLS, THERE IS A RISK
THAT MALFUNCTION AND/OR PHYSI-
CAL DAMAGE CAN OCCUR. IT IS
RECOMMENDED THAT YOU ALSO USE
FALL-PREVENTING WIRES, AND ETC.
INCOMPLETE INSTALLATION OF THE
HOOK MAY RESULT IN BODILY
INJURY WHEN USED.
a. Securely hold the main unit and remove the screw
using a slotted head screwdriver or a coin. (Fig. 6)
b. Remove the hook and spring. (Fig. 7)
c. Install the hook and spring on the other side and
securely fasten with screw. (Fig. 8)
NOTE: Pay attention to the spring orientation. Install the
spring with larger diameter away from you. (Fig. 8)
(Fig. 5)
(Fig. 6)
(Fig. 7)
(Fig. 8)