Filter
Top Products
REMOVING/ATTACHING BATTERY PACK
REMOVE BATTERY PACK:
1. Press both release buttons on either side of
the Cordless Drill to release the battery pack.
2. Pull battery pack free of Cordless Drill.
ATTACH BATTERY PACK:
1. Align the raised portion of the battery pack
with the groove in the battery compartment
of the Cordless Drill.
2. Press the battery pack into place. Make sure
the latches are securely fastened. Do not use
the Cordless Drill if the battery pack is not
seated properly.
CHARGER
Before using battery charger, please read carefully all
instructions and cautionary markings on battery charger, battery pack and
product using battery.
The charger will not automatically turn “OFF” when the
battery pack is fully charged. The charging indicator light will remain “ON”
until the charger is disconnected from the electrical outlet.
Use only the charger which accompanied your product or direct replacement as
listed in this manual. Do not substitute any other charger. Use only Alltrade
approved chargers with your product.
Do not disassemble charger.
Do not use charger if it has been damaged, left outdoors in the rain, snow, wet
or damp environments, or immersed in liquid.
The battery pack and charger heat during charging. Place the charger on a flat,
non-flammable surface away from flammable materials with at least four inches of
clearance to allow proper air circulation around the charger and battery pack.
When the battery pack requires recharging, a 3-5 hour charge allows the tool to
operate at full power. A charging indicator light on the charger will illuminate to
show that charging is taking place.
CHARGING BATTERY PACK
CHARGE BATTERY PACK:
1. Make sure the trigger
on the Cordless Drill
is in the “OFF” position
and remove the battery
pack from the Cordless Drill.
2. Plug 120V AC Adapter
into household outlet
and into side of battery
charger. Insert battery
pack into battery charger.
When the battery is placed in
the charger, the red LED
indicator light will remain on.
3. When fully charged, reattach battery pack onto Cordless Drill, making certain
latches fasten securely. Cordless Drill will not operate properly if the battery
pack is not seated properly.
ASSEMBLY
Be aware that this tool is always in an operating condition
because it does not have to be plugged into an electrical outlet. Always turn
the switch “OFF” and remove the battery pack before changing bits.
1211
RELEASE
BUTTON
BATTERY
CHARGER
BATTERY PACK
120V AC
ADAPTER
LED LIGHT