Filter
Top Products
4. Slide the collet nut over the drive shaft and thread it onto the motor shaft by
turning the collet nut clockwise. Tighten the collet nut using the collet wrench.
5. Remove the right angle attachment adapter and collar from the right angle
attachment by turning the collar counterclockwise.
6. Fasten the angle attachment adapter and collar to the tool by turning the right
angle attachment adapter clockwise.
Only tighten by hand. DO NOT use pliers or wrench.
7. Insert the end of the drive shaft into the hole in the right angle attachment.
Rotate the right angle attachment collet nut as you push
the right angle attachment onto the adapter until the square end of the drive
shaft inserts into the matching square in the right angle attachment.
8. When drive shaft is fully engaged into the right angle attachment, lock the right
angle attachment to the adapter by turning the adapter collar clockwise.
Only tighten by hand. DO NOT use pliers or wrench.
To change collet and accessories in the right angle attachment, use the same pro-
cedures as outlined for the flexible shaft.
18
CHANGING COLLET AND ACCESSORIES IN FLEXIBLE SHAFT
To change the collet or install an accessory in the flexible shaft, follow the same
general procedure as for changing the collet and for installing accessories on the
rotary tool. To lock the spindle, rotate the collet until the hole in the shaft is aligned
with the hole in the flexible collar. Insert the L-key through the holes to lock the
shaft.
Do not attempt to loosen or tighten the collet without
locking the shaft as noted above. Damage to the flexible shaft with result.
INSTALLING RIGHT ANGLE ATTACHMENT
(MODELS 840168 AND 840169)
1. Remove spindle nut from the tool by turning it counterclockwise.
2. Remove the collet nut and the collet from the motor shaft.
3. Insert the short end of the drive shaft into the motor shaft until the stopper
touched the shaft.
17
L-KEY