Filter
Top Products
4. Slide the collet nut over the drive shaft and thread it onto the motor shaft by
turning the collet nut clockwise. Tighten the collet nut using the collet wrench.
5. Remove the right angle attachment adapter and collar from the right angle
attachment by turning the collar counterclockwise.
6. Fasten the angle attachment adapter and collar to the tool by turning the right
angle attachment adapter clockwise.
Only tighten by hand.
DDOO NNOOTT
use pliers or wrench.
7. Insert the end of the drive shaft into the hole in the right angle attachment.
Rotate the right angle attachment collet nut as you push the
right angle attachment onto the adapter until the square end of the drive shaft
inserts into the matching square in the right angle attachment.
8. When drive shaft is fully engaged into the right angle attachment, lock the right
angle attachment to the adapter by turning the adapter collar clockwise.
Only tighten by hand.
DDOO NNOOTT
use pliers or wrench.
To change collet and accessories in the right angle attachment, use the same
procedures as outlined for the flexible shaft.
16
Only tighten flexible shaft nut finger tight.
DDOO NNOOTT
use
pliers or wrench.
CCHHAANNGGIINNGG CCOOLLLLEETT AANNDD AACCCCEESSSSOORRIIEESS IINN FFLLEEXXIIBBLLEE SSHHAAFFTT
To change the collet or install an accessory in the flexible shaft, follow the same
general procedure as for changing the collet and for installing accessories on the
rotary tool. To lock the spindle, rotate the collet until the hole in the shaft is aligned
with the hole in the flexible collar. Insert the L-key through the holes to lock the
shaft.
DDoo nnoott aatttteemmpptt ttoo lloooosseenn oorr ttiigghhtteenn tthhee ccoolllleett wwiitthhoouutt
lloocckkiinngg tthhee sshhaafftt aass nnootteedd aabboovvee.. DDaammaaggee tto
o tthhee fflleexxiibbllee sshhaafftt wwiitthh rreessuulltt..
IINNSSTTAALLLLIINNGG RRIIGGHHTT AANNGGLLEE AATTTTAACCHHMMEENNTT
FFOORR MMOODDEELLSS 884400116688 AANNDD 884400116699::
1. Remove spindle nut from the tool by turning it counterclockwise.
2. Remove the collet nut and the collet from the motor shaft.
3. Insert the short end of the drive shaft into the motor shaft until the stopper
touched the shaft.
15
L-KEY