Filter
Top Products
AATTTTAACCHHIINNGG AAUUXXIILLIIAARRYY HHAANNDDLLEE
This tool comes with an auxiliary
handle which can be attached to the
left, right or top side of the Angle
Grinder, depending on the prefer-
ence of the operator. This handle is
necessary to maintain complete
control of the tool and should be
used at all times. Make sure this
handle is always fastened securely.
AATTTTAACCHHIINNGG WWHHEEEELL GGUUAARRDD
NNeevveerr bbrruusshh oorr ggrriinndd wwiitthhoouutt tthhee gguuaarrdd iinn ppllaaccee..
Brushes
are considered to be grinding wheels and must also be used with guards.
• Always unplug the tool before attempt-
ing to change the guard or accessories.
• Set the Angle Grinder on a flat surface
with the spindle facing up.
• Place the spring washer of the guard
over the spindle.
• Tighten the screw of the spring washer.
• Make sure that the guard is secure-
ly tightened in place.
Wheel size MUST match guard size. A 7" wheel may not be
used in a 9" guard.
FFUUNNCCTTIIOONNAALL DDEESSCCRRIIPPTTIIOONN
CCOONNTTRROOLLSS AANNDD CCOOMMPPOONNEENNTTSS::
1. ON/OFF Switch with Locking Tab
2. Tool Body
3. Protective Guard
4. 9" Grinding Wheel
5. Spindle Lock Button
6. Power Cord
CCOOMMPPOONNEENNTT MMOODDEELL NNUUMMBBEERR
Pin Spanner 690157
AASSSSEEMMBBLLYY
MMaakkee ssuurree yyoouu hhaavvee ffuullll ccoonnttrrooll ooff tthhee ttooooll wwhheenn ggrriinnddiinngg
iinnttoo aa ccoorrnneerr aass aa sshhaarrpp,, ssuuddddeenn m
moovveemmeenntt mmaayy ooccccuurr wwhheenn tthhee wwhheeeell
ccoonnttaaccttss aa sseeccoonnddaarryy ssuurrffaaccee..
9
AACCCCEESSSSOORRIIEESS::
7. Side Handle
8. Pin Spanner
9. Hex Wrench
10. 7" Grinding Wheel
5
4
8
3
6
10
9
3
7
1
2