Filter
Top Products
AATTTTAACCHHIINNGG WWIIRREE BBRRUUSSHHEESS
Wire cup brushes, not included, can be screwed directly on the spindle. No flanges are
necessary.
EEDDGGEE GGRRIINNDDIINNGG
DDoo nnoott uussee eeddggee ggrriinnddiinngg wwhheeeellss ffoorr ccuutt--ooffff wwoorrkk,, ddeeeepp
ggrriinnddiinngg oorr ssuubbjjeecctt tthheemm ttoo aanny
y ssiiddee pprreessssuurree aass tthhiiss mmaayy lleeaadd ttoo bbrreeaakkaaggee
aanndd ppoossssiibbllee ppeerrssoonnaall iinnjjuurryy..
These wheels should be used for shallow cutting
and notching (less than 1/2" in depth). Keep the open side of the guard away
from the operator at all times.
Edge grinding should only be done with wheels specifically designed for this purpose.
RREEMMOOVVIINNGG GGUUAARRDD FFOORR SSAANNDDIINNGG OORR UUSSIINNGG FFLLAATT WWIIRREE BBRRUUSSHHEESS
• Set the Angle Grinder on a flat surface with the spindle facing up.
• Remove the inner and outer flanges, unscrew spring washer and remove
the guard.
• Store these parts carefully.
• Replace the guard after the job is finished.
AATTTTAACCHHIINNGG SSAANNDDIINNGG DDIISSCC
• To remove the guard, see instructions given in the “Removing Guard for
Sanding or Using Flat Wire Brushes” Section above.
• Set the inner flange and outer flange on the spindle.
• Push in the spindle lock button. Turn the spindle until it locks into place.
• Once the spindle is locked, tighten the sanding disc by hand.
OOPPEERRAATTIINNGG TTHHEE AANNGGLLEE GGRRIINNDDEERR
AAllwwaayyss uunnpplluugg tthhee ttooooll bbeeffoorree aatttteemmppttiinngg ttoo cchhaannggee tthhee
gguuaarrdd oorr aacccceessssoorri
ieess..
For best tool control, material removal and minimal
loading, keep the angle between the disc and the work surface at approximate-
ly 30° when grinding and 10°-15° when sanding.
WARNING
12
AATTTTAACCHHIINNGG WWHHEEEELLSS WWIITTHH DDEEPPRREESSSSEEDD CCEENNTTEERRSS
AAllwwaayyss cchheecckk tthhee ttooooll wwaarrnniinngg llaabbeell ffoorr tthhee rreeccoommmmeenndd--
eedd ssppeeeedd rraattiinngg oonn aacccceessssoorriieess..
Never run a wheel or brush over the rated
speed. Accessories exceeding the recommended speed may fly apart and cause
serious personal injury.
HHuubbbbeedd wwhheeeellss ddoo nnoott rreeqquuiirree mmoouunnttiinngg ffllaannggeess..
• When working with thick grinding
wheels, fit the threaded outer flange
with the raised area facing away
from the wheel.
• Push in the spindle lock button.
Turn the outer flange until it locks
into place.
• Once the spindle is locked, insert
the enclosed wrench into the holes
of the outer flange to tighten the
outer flange properly.
WARNING
11
SPINDLE
LOCK
BUTTON
• Check to make sure that the guard is fit-
ted properly. Put the inner flange on
the spindle.
• Put the grinding wheel on the spindle
and the inner flange.
• When working with thin grinding wheels,
fit the threaded outer flange with the
raised area facing toward the wheel.