Filter
Top Products
AASSSSEEMMBBLLYY
Always make sure that the power cord is unplugged and the trigger switch is
“OFF” before changing blades or attachments.
WWhheenn rreemmoovviinngg tthhee bbllaaddee ffrroomm tthhee ttooooll,, aavvooiidd ccoonnttaacctt wwiitthh sskkiinn aanndd uussee
pprrooppeerr pprrootteeccttiivvee
gglloovveess wwhheenn ggrraassppiinngg tthhee bbllaaddee oorr aacccceessssoorryy..
Accessories
may be hot after prolonged use.
If the blade clamp screw will not loosen enough to allow
blade installation, tap gently on the end of the wrench with a mallet until the
clamp screw breaks free.
ATTACHING / REMOVING BLADE
Only use sharp and undamaged saw blades. Cracked
or bent saw blades must be replaced immediately.
REPLACING THE SAW BLADE:
1. Keep the spindle lock button
depressed and rotate the saw blade
by hand until it is blocked. Keep the
spindle lock depressed.
2. Loosen the blade bolt and remove it.
3. Remove the flange.
11
MOUNTING THE RIP FENCE
MOUNTING THE RIP FENCE:
The rip fence allows sawing parallel
to an edge at a maximum distance
of 10cm.
1. Loosen the lock knob.
2. Insert the rip fence into the saw base
as shown in the illustration.
3. Set the lock knob to the required
distance.
4. Tighten the lock knob.
CUTTING DEPTH ADJUSTMENT
Disconnect plug from power supply before making any
adjustments to the tool.
1. Hold the saw firmly.
2. Raise the depth adjustment lever to
loosen and move shoe to obtain the
desired depth of cut.
3. Make sure the depth adjustment lever
has been retightened (lowered) before
operating saw.
Your saw is equipped with a carbide tipped blade for long life and efficient cutting.
Setting the saw at the proper cutting depth keeps blade friction to a minimum,
removes sawdust from between the blade teeth, results in cooler, faster sawing
and reduces the chance of kickback. Align the appropriate mark on the depth
adjustment strap with the triangle on the upper blade guard. Your depth is set.
For the most efficient cutting action using a carbide tipped blade, set the depth
adjustment so that about one half of a tooth projects below the surface of the
wood to be cut.
4.Hold the saw blade guard open.
5. Remove the old saw blade and
place the new saw blade with the
teeth pointing in the direction of
rotation. See arrow on the housing.
6.Move the saw blade guard back
into its normal position.
7.Place the flange on the saw blade
and secure the blade bolt.
8.Release the spindle lock button.
12
LOOSEN
TIGHTEN