Filter
Top Products
10-5508 Rev A Service Department (800) 888-70093
Step Two: Remove hoses
After the screws have been removed, take the ½ inch open-ended wrench, and loosen the
nut that connects the hose to the valve by turning it counter-clockwise, and remove the
hose.
Unscrew nut counter-clockwise
Next, cut the hose to the plastic elbow 3/8 inch from the end of the plastic elbow using
the wire cutter.
cut tubing
Repeat steps one and two to dismount the second valve before proceeding to step three.
Step Three: Remove electrical wires
First, clip the zip tie that is holding the four wires to the valves outside of the
compressor.
cut ties