Filter
Top Products
- 2 -
HALOGEN WORK
SPOTLIGHTS
Safety instructions
ƽ
Danger of electrical shock!
• Only connect the Stand Halogen Floodlight to
correctly installed wall sockets having a mains
current of 220 - 240 V at 50 Hz.
• Unplug the Stand Halogen Floodlight from the
socket if you notice any faulty operation and
when you decide to clean it.
• Under no circumstances may the Stand Halogen
Floodlight be immersed in liquids, or liquids be
permitted to permeate into the housing.
Should liquids nonetheless gain entry into the
appliance housing, immediately unplug the ap-
pliance from the mains supply and arrange for it
to be repaired by qualified specialists.
• Never touch the Stand Halogen Floodlight,
power cable or plug with wet hands
• To unplug the appliance, always pull the plug
from the socket, do not pull the cord itself
• Do not crease or crimp the power cable and
place it in such a way as to prevent anyone from
stepping on or tripping over it.
• To avoid the risk of injury, arrange for defective
power plugs and/or cables to be replaced as
soon as possible by a qualified technician or by
our Customer Service Department to avoid the
risk of injury.
• Separate your Stand Halogen Floodlight from
the mains supply immediately after use.The
appliance is only completely switched off after
having been unplugged.
ƽ
Danger of injuries
• If they have not previously been supervised or in-
structed in its correct usage, do not allow indivi-
duals (including children) to use the appliance
whose physical, sensorial or mental abilities or
lack of experience and knowledge hinder their
safe usage of it if they have not previously been
supervised or instructed in its correct usage.
• Inform children about the appliance and its
potential dangers and that they should not play
with it.
ƽ
Attention
• Always remove the plug from electrical sockets
before exchanging the halogen lamps.
• Allow the halogen lamps to cool before
removing them.
• Switch the Stand Halogen Floodlight off only
with the ON/OFF switch.
• Never touch the glass covering, the power cable
or the metal housing whilst it is in operation.
These parts of the appliance will become very
hot during use.
To avoid burn injuries, do not touch these
surfaces!
• Arrange for a defective glass cover to be imme-
diately replaced by a suitable new one.
• Never direct the halogen floodlights towards
each other. The appliance could be damaged
by the large generation of heat.
• Always ensure that the Stand Halogen Flood-
light is sufficiently distant from yourself and easi-
ly meltable items.
• To avoid eye damage, do not look directly into
the Stand Halogen Floodlight.
• Never place the Stand Halogen Floodlight in the
close proximity of easily inflammable materials.
• Use exclusively halogen lamps up to 500 Watt.
• Never touch the lightbulb with bare hands.
Always use a dry lint-free cloth.
• Read and observe all safety and operating
instructions.
• Ensure that the Stand Halogen Floodlight has
cooled down before storing it away.
IB_KH4077_BK1968_LB6 30.11.2007 14:47 Uhr Seite 2