7 GB
Introduction / General safety advice for electrical power tools
Q
Technical information
Nominal voltage: 230 V
~
50 Hz
Impact cycles:
30 / min
Short-term
operation time (KB):
max. 15 min
Protection class: II /
Noise and vibration data:
The sound pressure level (A-weighted) of the
device is typically 95,0 dB(A). The sound level while
working can exceed 108,0 dB (A).
Wear ear protection!
Evaluated acceleration, typical:
Hand / arm vibration a
h
= 5,54 m / s
2
WARNING!
The vibration level given in these
instructions has been measured in accordance with
a standardised measurement procedure and can
be used to compare devices.
Different uses of the device give rise to different
vibration levels and in many cases they may exceed
the values given in these instructions. In some cir-
cumstances it is easy to underestimate the vibration
load if the electrical power tool is used regularly.
Note: If you wish to make an accurate assessment
of the vibration loads experienced during a particular
period of working, you should also take into account
the intervening periods of time when the device is
switched off or is running but is not actually in use.
This can result in a much lower vibration load over
the whole of the period of working.
PET 23 VARIO
KH 3145
230 V
˜
50 Hz
Date of manufacture: 04-2008
Kompernaß GmbH · 44867 Bochum (Germany)
www.kompernass.com
30 /min
Type 53
12 - 18 mm
KB
max.
15 min
Type 55
12 - 19 mm
Type 47
23 mm
I
D
:
0
0
0
0
0
2
2
2
3
2
General safety advice for
electrical power tools
WARNING!
Read all the safety advice
and instructions!
Failure to observe the safety advice and instructions
may result in electric shock, fire and / or serious injury.
KEEP ALL THE SAFETY ADVICE AND INSTRUCTIONS
IN A SAFE PLACE FOR FUTURE REFERENCE!
1. Workplace safety
a) Keep your working area clean and
well lit. Untidy or poorly lit working areas
can lead to accidents.
b)
Do not work with the device
in potentially explosive envi-
ronments in which there are
inflammable liquids, gases or dusts.
PET23_ELECTRIC STAPLE GUN_Content_LB4.indd 7 25.04.2008 9:19:15 Uhr