7 GB
10
Wing screw for guide fence
11
Guide fence slot
12
Guide fence
13
Laser unit
14
Laser ON / OFF switch
15
Cutting depth scale
16
Riving knife
17
Auxiliary handle
18
Drive spindle
19
Mounting flange
20
Clamping flange
21
Clamping screw with washer
22
Riving knife mounting
23
Mounting screws
24
Adapter for vacuum sawdust removal
Q
Included items
1 Circular saw
1 Guide fence
1 Adapter for vacuum sawdust removal
1 Allen key
2 Batteries, micro AAA 1.5 V (for laser)
1 Operating instructions
1 „Warranty and service“ booklet
Q
Technical information
Nom. power input: 1450 W
Rated voltage: 230 V
~
50 Hz
Mechanical output: 15 Nm max.
No-load speed: n
0
1800 - 5000 min
-1
Saw blade: 210 x 30 x 1.8 x 2.6 mm
Cutting depth at 90°: 0 - 75 mm
Cutting depth at 45°: 0 - 49 mm
Protection class: II / &
Noise and vibration data:
Values determined in accordance with EN 60745
The sound pressure level (A-weighted) of the device
is typically 107,5 dB (A). Uncertainty K=3 dB. The
sound level while working can exceed 120,5 dB (A).
Wear ear protection!
Evaluated acceleration, typical:
Hand / arm vibration a
h
= 2,309 m / s
2
Uncertainty K = 1,5 m / s
2
WARNING!
The vibration level given
in these instructions has been measured in
accordance with a standardised measurement
procedure specified in EN 60745 and can be used
to compare devices. Different uses of the device
give rise to different vibration levels and in many
cases they may exceed the values given in these
instructions. It is easy to underestimate the vibration
load if the electrical power tool is used regularly in
particular circumstances.
Note: If you wish to make an accurate assessment
of the vibration loads experienced during a particular
period of working, you should also take into account
the intervening periods of time when the device is
switched off or is running but is not actually in use.
This can result in a much lower vibration load over
the whole of the period of working.
Q
General safety advice
J Attention! Please read all the instructions
and advice. Failure to observe the instructions
and advice given below may result in electric
shock, fire and / or serious injury.
Introduction / General safety advice