Filter
Top Products
SGF SEAT GRINDER
WHEEL TIGHTENING
In case the grinding wheel should stick on the grinder unit, take the wooden blocks from the box
and use them as shown below. In doing this, be sure to place the blocks up close to the wheel
(within 1/8”) so the pressure will be taken by the bearing area of the unit rather than by the thin
wall in the center. This will avoid any possible damage to the unit.
After gripping the unit tightly, you should be able to unscrew the wheel with the hand. If this
cannot be done, the strap-type wrench furnished will loosen the wheel.
CAUTION: Never grip either the grinding unit or grinding wheel directly in a vise. The body of
the grinding unit could easily be damaged by doing so or the wheel very likely broken.
KW Products Inc. 800-553-5953
8.
500 57
th
Street, Marion, IA 52302 USA
Copyright 2004 All Rights Reserved
Equipment specifications, options and accessories subject to change without