Filter
Top Products
SGF SEAT GRINDER
MAINTENANCE
Your Kwik-Way SGF Seat Grinder is designed to require minimal maintenance. However, some
basic maintenance assures the unit will continue to operate in a satisfactory manner.
1. The motor features permanently sealed bearings that require no routine oiling.
2. The gears located in the nose housing may require lubrication on a yearly basis. (depending
on use) We recommend the following:
a. Remove the four cap screws and two pan head screws holding the nose to the motor
housing.
b. Keep the motor armature in place by holding against the fan with a screwdriver (prevents
armature from slipping out of the brushes) and remove the nose housing.
c. Once removed, add approximately one teaspoon of grease to the gear cavity of the
housing.
CAUTION: Do not overfill, excess grease will cause the gears to run hot.
3. Brushes should be removed and inspected for wear every 3 months or sooner depending on
use, replace them as required.
KW Products Inc. 800-553-5953
11.
500 57
th
Street, Marion, IA 52302 USA
Copyright 2004 All Rights Reserved
Equipment specifications, options and accessories subject to change without