Filter
Top Products
C-2
ACCESSORIES
C-2
RANGER 10,000 PLUS AND RANGER 10,000
RECOMMENDED EQUIPMENT
STICK
K704 ACCESSORY SET - Includes 35 ft. (10m) of
electrode cable and 30 ft. (9.1m) of work cable, head-
shield, work clamp electrode holder. Cables are rated
at 400 amps, 100% duty cycle.
K875 Accessory Kit - For stick welding. Includes 20 Ft. (6.1m).
#6 electrode cable with lug, 15 Ft. (4.6m) #6 work cable with
lugs, headshield, filter plate, work clamp, and electrode holder
and sample pack of mild steel electrode. 150 amp capacity.
WIRE FEED
K449 LN-25 - Includes internal contactor for across
the arc operation (no control cable). Provides “cold”
electrode until gun trigger is pressed. Includes gas
solenoid.
K1870-1 LN-15 Across the Arc
Magnum Gun and Magnum Gun Connector Kit are
required for gas-shielded welding. Innershield Gun is
required for gasless welding.
K126-2 Magnum 350 Innershield Gun (for LN-25, LN-
15).
K1802-1 Magnum 300 MIG Gun (for LN-25, includes
Connector Kit).
K470-2 Magnum 300 MIG Gun (for LN-15, requires
K466-10 Magnum Gun Connector Kit).
K1500-1 Gun Receiver Bushing (for LN-15, K126-2)
Note: See Wire Feeder IM Manual for appropriate
Drive Roll & Guide Tube Kits.
TIG WELDING
K1783-9- PTA-26V TIG Torch.
KP509- Magnum Parts Kit and Argon gas.
K930-2- TIG Module.
Required TIG Equipment:
K938-1 Connector Kit
K936-4 Control Cable
K814 Arc Start Switch
Optional TIG Equipment:
K939-1 Docking Kit
K937-45 Control Cable Extension
PLASMA CUTTING:
K1580-1 Pro-Cut 55
Cuts mild steel using the 3-phase AC generator power
from the engine driven welder. Accepts 3-phase or 1-
phase input power. Requires the K1816-1 Full KVA
adapter kit, if connected for 1-phase input power.