Filter
Top Products
C-1
ACCESSORIES
C-1
CLASSIC III AND IIID
OPTIONAL FEATURES (Field Installed)
Accessory Set (K703) - Includes electrode and work
cables, headshield, work clamp and electrode holder.
Hi-Freq
™
(K799) - Provides high frequency plus gas
valve for DC TIG welding.
Linc-Thaw™ (L2964-1) - Includes meter and fuses to
protect welder when thawing frozen water pipes.
Pipe Thawing IS
NOT a CSA approved procedure.
If not done properly, it can result in fire, explosion,
damage to wiring which may make it unsafe, dam-
age to pipes, burning up the welder, or other haz-
ards.
Do not use a welder to thaw pipe before reviewing
Lincoln Bulletin E695.1 (dated October 1987 or later.)
------------------------------------------------------------------------
Power Plug Kit (K802C) - A power plug kit for the
auxiliary power receptacles is available. (Provides a
plug for each receptacle.)
Remote Control Kit (K924-4) - Contains switch,
receptacle, remote control rheostat, and 100 ft
(30.5m) cable for adjusting the OCV at the welding
site.
Trailer (K768) - Two-wheeled trailer for in-plant and
yard towing at speeds under 10 mph only.
Trailer (K780) - Two-wheeled trailer with brakes,
lights and fenders. (For highway use, consult applica-
ble federal, state and local laws regarding possible
additional requirements.)
Trailer - Two-wheeled trailer with steel, torsion-bar
axle, 54” (137cm) wheel track. Low sway, low center-
of-gravity. Sturdy tread plate platform. Choice of 3
hitches. Add on fender & light package. For highway
use, consult applicable federal, state, and local laws
regarding possible additional requirements. Order:
K913-1 Trailer, K913-2 Ball Hitch, K913-3 Lunette
Eye Hitch, K913-4 Clevis Pin Hitch, K913-5
Fender & Light Kit.
Wire Feed Module (K623-1) - Provides constant
voltage (CV) output with improved arc stability for
Innershield welding. Excellent for MIG welding.
Recommended wire feeders are the LN-7, LN-23P
and LN-25. (Factory installed on the K1428-3 and
K1433-2).
WARNING