Filter
Top Products
A CLOSER LOOK
Key Controls
20
21
141312
11
10
1
5
6
8
9
18
17
16
1. Glow Plug Button
2. Weld Mode Selector Switch
3. Run/Stop Switch
4. Hour Meter
5. Start Push button
6. Engine Idler Switch
7. Fuel Level, Engine Temperature and
Oil Pressure Gauges
8. Engine Protection Light
9. Engine Battery Charging Light
10. 120 VAC Circuit Breakers
11. 120 VAC GFCI Receptacles
12. 120/240 VAC Full-KVA 1-Phase Receptacle
13. 240 VAC Full-KVA 3-Phase Receptacle
14. Full-KVA 1- & 3-Phase Circuit Breaker
15. Covered Weld Output Terminals + and -
16. Ground Stud
17. 14-Pin Wire Feeder Connector
18. 6-Pin Remote Control Connector
19. Arc Force & Inductance/Pinch Control Dial
20. Welding Terminals Control Switch
21. Wire Feeder Voltmeter Polarity Switch
22. Digital Amps and Volts Output Meters
23. VRD Indicator Lights
24. Output Control Dial
FEATURES
24 23
22
19
2
4
15
3
7
Note: Control panel door not shown.
Single-side engine access
with lockable sliding door.
Fuel, Oil Pressure and Engine
Temperature gauges help you
monitor performance.
Patent-pending latched
and lockable radiator cap
cover.
Convenient slide-out battery
drawer below control panel.
Handy oil drain valve and tube
makes oil changes easy.
Output automatically switches
to remote mode when remote
device is connected.
• Simple Controls – Keeps training time to a minimum. The flip-down
control panel door keeps less frequently used dials out of the way.
Scratch-resistant Lexan
®
nameplate.
• Digital weld meters for amps and volts output make it easy to
precisely set your procedures.
• Large 15 gallon (57 liter) fuel tank provides run time for an extended
day—12 hours of welding at 400A/36V/100% duty cycle output, or
36 hours at high idle.
• Great Engine Choice – 32.7 horsepower water-cooled 4 cylinder
Perkins
®
404D-22 diesel engine. Engine has an automatic idler for
greater fuel economy and reduced noise. Glow plug button for cold
weather starting.
• Engine hour meter for scheduled maintenance.
• LN-25 PRO Across-the-Arc wire feeder is a recommended option.
• 14-pin connector for Lincoln wire feeders with control cables LF-72,
LF-74, LN-7, LN-8, LN-15, LN-23P, LN-25 and LN-742. Also com-
patible with Magnum
®
SG Spool Gun System.
• Two Vantage
®
400 units can be paralleled in the CC-Stick Mode to
increase output.
Vantage
®
400
www.lincolnelectric.com
[3]