Filter
Top Products
A CLOSER LOOK
PERFORMANCE
• Provides line voltage compensation for maintaining weld consis-
tency, even with changes of ±10%.
• For heavy duty MIG and flux-cored applications.
• Sub-arc welding with up to 5/64” (2.0mm) diameter electrodes.
• Arc gouging up to 3/8” (10mm) carbons.
FEATURES
• Quick, simple 14-pin MS-type (Amphenol) wire feeder connection.
• Low flat-top case can be placed under a workbench or stacked
on top of each other for smaller footprint.
• “Cold” electrode with a solid state contactor when the trigger
is released for added safety.
• Thermal trip indicator light.
QUALITY AND RELIABILITY
• Electronic and thermostatic protection from current overload
or excessive temperatures.
• PC boards have built-in diagnostic routines for quick and easy
troubleshooting.
• Circuit boards are protected with a specially insulated coating to
extend life and ensure reliable performance.
• Solid state circuitry provides extra long life during repetitive
applications.
• Three-year warranty on parts and labor.
• Manufactured under a quality system certified to ISO 9001
requirements and ISO 14001 environmental standards.
• CSA approved for 60 Hz models.
SYSTEM SELECTION
CV-655 / LF-72 Heavy Duty Wire Feeder
• CV-655 Power Source K1480-1
• LF-72 Heavy Duty K2327-3
• 600 Amp Weld Power Cable – 10 ft. K1842-10
(2)
• Work Clamp K910-2
• Harris® Flowmeter Regulator and Gas Hose K586-1
CV-655 / LN-742 Wire Feeder
Best for applications where more process control is required – for
arc starting, welding and crater control!
• CV-655 Power Source K1480-1
• LN-742 (Two Roll) Wire Feeder K617-1
• Control Cable - 10 ft. K1819-10
• .045 Drive Roll KP653-052S
• Universal Stand K1524-1
• Swivel Platform K1557-1
• Magnum 400 Gun & Cable Assembly K2286-1
(1)
• 600 Amp Weld Power Cable – 10 ft. K1842-10
(2)
• Work Clamp K910-2
• Harris Flowmeter Regulator and Gas Hose K586-1
CV-655 / LN-10 Wire Feeder
Where premium welding performance and control is demanded –
this system delivers!
• CV-655 Power Source K1480-1
• LN-10 wire feeder K1559-1
• Control Cable – 10 ft. K1501-10
• .045 Drive Roll KP1505-045S
• Swivel Platform KP557-1
• Magnum 400 Gun & Cable Assembly K471-21
(1)
• 600 Amp Weld Power Cable – 10 ft. K1842-10
(2)
• Work Clamp K910-2
• Harris Flowmeter Regulator and Gas Hose K586-1
Typical MIG Welding Systems
CV-655
www.lincolnelectric.com
[2]
Key Controls
1. Optional Voltmeter and Ammeter
2. Output Voltage Control
3. Pilot Light
4. Thermal Protection Light
5. Input Power On/Off Switch
6. Local/Remote Control Switch
7. Output Terminals On/Remote Switch
1.
2.
3.
4.
5.
6.
7.