Filter
Top Products
A-2
INSTALLATION
WELD-PAK 100 JAN96
Read entire installation section before starting
installation.
SAFETY PRECAUTIONS
IDENTIFY AND LOCATE
COMPONENTS
If you have not already done so, unpack the Weld-Pak
100 from its carton and remove all packing material
around the WELD-PAK 100. Remove the following
loose items from the carton (see Figure A.1):
1. WELD-PAK 100
2. Gun and cable assembly
(1)
3. Literature and miscellaneous including:
a) This operating manual
b) 10 extra .035" contact tips
c) Hex key wrench for removal of drive roll.
4. 10 ft (3,0 m) work cable.
5. Work clamp.
6. Sample 10 lb. spool of Innershield .035" (0,9 mm)
NR-211-MP electrode.
7. Handshield with filter plate and lens.
8. Instructional video.
9. 8” Spool Adapter (2” Spindle) for mounting 10 lb.
Spools
10. Chipping hammer/wire brush
For available options and accessories refer to the
Accessories Section of this manual.
(1)
The gun is ready to feed 0.035" (0,9 mm)
Innershield wire.
ELECTRIC SHOCK can kill.
• Only qualified personnel should perform
this installation.
• Only personnel that have read and under-
stood the WELD-PAK 100 Operating
Manual should install and operate this
equipment.
• Machine must be plugged into a receptacle
which is grounded per any national, local
or other applicable electrical codes.
• The WELD-PAK 100 power switch is to be
in the OFF (“O”) position when installing
work cable and gun and when connecting
power cord to input power.
WARNING
FIGURE A.1
WELD-PAK100
WELD
-
P
AK10
0
1
2
3
4
5
6
7
8
10
10
9