Filter
Top Products
F-9
DIAGRAMS
F-9
COMMANDER 300
CONNECTION DIAGRAM:
WIRE FEEDER "B"
N.B.
602
FEEDER "A"
604
75
76
77
14 PIN AMPHENOL
M17866
N.D. IF REMOTE OUTPUT CONTROL IS USED,
PLACE LOCAL/REMOTE SWITCH IN "REMOTE"
N.E THE OUTPUT CONTROL SWITCH MUST BE IN
THE "WELDING TERMINALS REMOTELY
ELECTRODE
WELDER, SPECIAL CARE IS TO BE
CAUTION: WHEN MOUNTING ADAPTER TO
MACHINE COMPONENTS, SUCH AS/BUT
SCREWS
LN-23P
4-3-98F
INSTALLATION INSTRUCTIONS
604
75
602
76
77
N.A.
ELECTRODE
WORK
115 VAC AUXILIARY
ENGINE WELDER WITH
ELECTRODE
ONTO THE WELDER.
THEM TO FASTEN THE ADAPTER KIT ASSEMBLY
2. REMOVE THE THREE SCREWS SHOWN AND USE
HAS A HALF INCH SQUARE HOLE IN IT.
ASSEMBLY WITH THE ADAPTER BRACKET THAT
1. REPLACE EXISTING BRACKET ON ADAPTER KIT
TO
WORK
ENGINE WELDER
&200$1'(572/13:,7+$'$37(5.,7
RUVHUYLFHWKLVHTXLSPHQW
2QO\TXDOLILHGSHUVRQQHOVKRXOGLQVWDOOXVH
.HHSDZD\IURPPRYLQJSDUWV
'RQRWRSHUDWHZLWKSDQHOVRSHQ
OPERATING INSRTUCTIONS
'LVFRQQHFW1(*$7,9(%$77(5</($'
EHIRUHVHUYLFLQJ
'RQRWWRXFKHOHFWULFDOO\OLYHSDUWV
CAPACITY FOR THE CURRENT AND THE
N.A. WELDING CABLES MUST BE OF PROPER
DUTY CYCLE OF IMMEDIATE AND FUTURE
APPLICATIONS. SEE OPERATING MANUAL
.HHSJXDUGVLQSODFH
FOR PROPER SIZES.
TO FEEDER "A" TERMINAL STRIP IN
N.B. IF ONLY ONE LN-23P IS USED, CONNECT
ADAPTER.
DESIRED ELECTRODE POLARITY. POSITION
N.C. USE VOLTMETER SWITCH TO SELECT
THE SELECTOR SWITCH TO "WIRE WELDING
K350-1
CV".
521
FEEDER "B"
LN-23P ADAPTER KIT
521
WARNING
9 CONDUCTOR ADAPTER CABLE
POSITION.
LN-23P
WIRE FEEDER "A"
&211(&7,21',$*5$0,167$//$7,21'(7$,/
TAKEN AS NOT TO DAMAGE ANY
CONTROLLED" POSITION.
NOT LIMITED TO ELECTRICAL
COMPONENTS, WIRES OR FUEL TANKS.