Filter
Top Products
D-3
MAINTENANCE
D-3
ENGINE ADJUSTMENTS
OVERSPEED IS HAZARDOUS
The maximum allowable high idle speed for this
machine is 3750 RPM, no load. Do NOT tamper
with governor components or setting or make any
other adjustments to increase the maximum
speed. Severe personal injury and damage to the
machine can result if operated at speeds above
maximum.
------------------------------------------------------------------------
Adjustments to the engine are to be made only by a
Lincoln Service Center or an authorized Field Service
Shop.
SLIP RINGS
A slight amount of darkening and wear of the slip rings
and brushes is normal. Brushes should be inspected
when a general overhaul is necessary.If brushes are
to be replaced, clean slip rings with a fine emery
paper.
Do not attempt to polish slip rings while engine is
running.
------------------------------------------------------------------------
BATTERY
1. When replacing, jumping, or otherwise connecting
the battery to the battery cables, the proper
polarity must be observed. Failure to observe
the proper polarity could result in damage to the
charging circuit. The positive (+) battery cable
has a red terminal cover.
2. If the battery requires charging from an external
charger, disconnect the negative battery cable
first and then the positive battery cable before
attaching the charger leads. Failure to do so
can result in damage to the internal charger
components. When reconnecting the cables,
connect the positive cable first and the negative
cable last.
HARDWARE
Both English and Metric fasteners are used in this
welder.
EAGLE 10,000
WARNING
GASES FROM BATTERY can explode.
• Keep sparks, flame and cigarettes
away from battery.
To prevent EXPLOSION when:
• INSTALLING A NEW BATTERY - dis-
connect negative cable from old bat-
tery first and connect to new battery
last.
• CONNECTING A BATTERY CHARG-
ER - Remove battery from welder by
disconnecting negative cable first,
then positive cable and battery clamp.
When reinstalling, connect negative
cable last. Keep well ventilated.
• USING A BOOSTER - connect positive lead to
battery first then connect negative lead to engine
foot.
BATTERY ACID CAN BURN EYES AND
SKIN.
• Wear gloves and eye protection and
be careful when working near battery.
Follow instructions printed on battery.
-----------------------------------------------------------------------
WARNING
CAUTION
KOHLER C20S
KOHLER 1205001
Oil Filter FRAM PH3614*
Air Filter KOHLER 4708303
Element FRAM CA79
Air Filter KOHLER 2408302
Pre-Cleaner
Fuel Filter KOHLER 2505002
FRAM G1
Spark Plugs CHAMPION RC12YC
(Resistor (.030” GAP)
Type)
* Oil capacity increases from 2.0 Qts. to 2.1
Qts. when using this filter.
ENGINE MAINTENANCE PARTS