Filter
Top Products
INSTALLATION
c. Insert the control cable plug from the feeder trigger
circuit into the mating socket on the gun cable con-
nector handle. For machines with a twist-lock trig-
ger lead receptacle, if the L-Tec gun control cable
does not easily connect with the socket, the gun
control cable that came with the K466-5 kit can be
used. To do this, cut off the gun control leads as
close to the forked terminals as possible and skin
back the leads 7/16” (11 mm). Remove the twist-
lock plug from the L-Tec control cable and connect
it to the K466-5 cable. Make sure the outer jacket of
the connector is caught within the plug’s strain
relief.
CONNECTION TO LINCOLN WIREMATIC, HOBART
SERIES 2000 FEEDERS, OR SP100T TYPE FEEDERS.
Gun cable asssemblies which were assembled with a
K466-6, K466-7 or K466-9 Connection Kit will connect
easily to a feeder.
a. Check that the adapter and feeder outgoing guide,
as well as the drive roll, are appropriate for the elec-
trode size being used.
b. Fully push the brass connector end of the gun cable
into the outgoing side of the feeder wire drive.
Secure the cable using the hand screw on the wire
feeder.
c. Insert the control cable plug from the feeder trigger
circuit into the mating socket on the gun cable con-
nector handle.
CONNECTION TO LINCOLN 10 SERIES FEEDERS
Gun cable assemblies which were assembled with a
K466-10 Connection Kit or K471-21 thru -23 gun and
cable assemblies will connect easily to a 10 Series
feeder.
a. Check that the K1500-2 gun adapter is in place on
the wire feeder. Check that the feeder guide tubes,
as well as the drive roll(s), are appropriate for the
electrode size being used.
b. Fully push the brass connector end of the gun cable
into the gun adapter on the outgoing side of the
feeder wire drive and secure the cable using the
hand screw.
c. Insert the control cable plug from the feeder trigger
circuit into the mating socket on the gun cable con-
nector handle.
MAGNUM 300 & 400
B-5B-5