Filter
Top Products
6
If you want to add a node at the end of the line (as shown in the previous
figure), remove the terminator from the very last connector, securely
attach the new T connector, and then attach the terminator on the new
connector. Either method will allow you to add a device.
The "soft" T connector, shown above with a "hard" T connector, is another
option for connecting devices in a NMEA 2000 network. The soft T works
the same as a hard T. The soft T is used to install a network node in areas
were a hard T will not fit.
Additional Network Information
Further instructions on creating or expanding a network are illustrated
in the NMEA 2000 network setup booklet, part number 988-0154-172,
which came packed with this instruction sheet.