Filter
Top Products
NOTE: The Fan Mode switch only works if your system provides a wire for
the thermostat’s “G” wire terminal, to control a blower fan. The Fan Mode
switch has no effect in systems that do not have a blower fan (such as a hot
water radiator system).
TOUCHSCREEN MENU CONTENTS:
• SET DAY/TIME
• SET/REVIEW “HEAT/COOL” PROGRAMS (not present in OFF mode)
• SET/REVIEW FILTER USAGE
• REVIEW “HEAT/COOL” ENERGY USAGE (not present in OFF mode)
• SET/REVIEW SWING VALUE
• SET KEYBOARD LOCK CODE (not present in OFF mode)
• SET “HEAT/COOL” TEMPERATURE STOP (not present in OFF mode)
• TEMPERATURE SETBACK (not present in OFF mode)
SET DAY AND TIME: Press the MENU button. The first menu item shown is
“SET DAY/TIME”, press the OK button. With the day flashing, press UP or
DOWN to set the day of the week. Press NEXT and the clock time will start
flashing. Use UP or DOWN to set the time, making sure the AM/PM
indication is correct. Holding the UP or DOWN buttons will make the clock
digits scroll rapidly. Press the EXIT button to return to the Normal Run
screen.
HEATING AND COOLING: Basic operation of your heating or cooling system
can be obtained by choosing either HEAT or COOL on the System Mode
switch. Touch the Set Temperature digits on the screen and they will begin
to flash. While they are flashing, the UP and DOWN buttons will be shown
also, which you can use to adjust the current Set Temperature. When the
thermostat is first powered up, it will follow a default temperature routine
that is preset from the factory (shown below), until the clock has been set.
20
OPERATING INSTRUCTIONS: