Filter
Top Products
STATIC NOTICE: This thermostat is protected against normal static electric
discharges, however to minimize the risk of damaging the unit in extremely
dry weather, please touch a grounded metal object before touching your
thermostat.
By default, this thermostat has 4 separate program periods for both Heat and
Cool mode, they are: MORN, DAY, EVE, and NITE. Each period ends at the
start time of the following period. The heat programs are set in HEAT mode,
and the cool programs are set in COOL mode.
NOTE: If the thermostat is configured to use only 2 periods per day instead
of 4 (HARDWARE SETUP OPTIONS), the thermostat will only use the DAY
and NITE periods. The MORN and EVE periods will not be visible on the
screen.
The following examples are shown using Heat mode. Programming in Cool
mode is done in the same exact manner with the System Mode switch in the
Cool position.
SET TEMPERATURE PROGRAMS: Press the MENU button, then press the
SCROLL button until “SET/REVIEW HEAT PROGMS” is shown, then press the
OK button to enter the programming screen. Use the UP and DOWN buttons
to adjust the start time for the MORN period, then press the NEXT button to
advance. Use the UP and DOWN buttons to adjust the set temperature for
the MORN period, then press the NEXT button to advance. Now adjust the
start time and set temperature for the DAY period, pressing the NEXT button
after each to advance. Continue with these same steps to adjust the start
times and set temperatures for the EVE and NITE program periods.
When the NITE period is finished the thermostat will advance to Tuesday,
with the MORN period start time flashing. Perform the same steps that you
used for setting the Monday periods, pressing the NEXT button to advance
through each flashing value.
PROGRAM COPY FEATURE: The Copy feature allows you to copy all of the
program information from any one single day, to any other day of the week.
To copy heat programs, the thermostat must be in Heat mode, and to copy
cool programs, the thermostat must be in Cool mode. Emergency Heat (heat
pump configurations only) uses the Heat temperature program. While in a
temperature programming screen, press the “COPY” button one time. The
23
TEMPERATURE PROGRAMS: