Filter
Top Products
PRE
LlMl NAR
Y
I
NSTR UCTl ONS
Your electric tool
is
precision built and manufactured
to
satisfy the highest standards. For maximum
performance,
long
tool life, and your safety, follow these instructions carefully.
VOLTAGE WARNING: Before connecting the tool to
a
power source (receptacle, outlet, etc.) be
sure the voltage supplied
is
the same as that specified
on
the nameplate of the tool.
A power source
with voltage greater than that specified for
the
tool can result
in
SERIOUS INJURY to the user
-
as
well as damage to the tool. If
in
doubt,
DO
NOT PLUG
IN
THE TOOL. Using a power source with
voltage
less
than the nameplate rating
is
harmful
to
the motor.
For
all
grounded
tools
with
American type plug.
GROUNDING INSTRUCTIONS: This tool should be grounded while
in
use to protect
the
operator
from electric shock. The tool
is
equipped with an approved three-conductor cord and threeprong
grounding-type plug to fit the proper grounding-type receptacle. The green (or green and yellow)
conductor
in
the
cord
is
the grounding wire. Never connect the green (or green and yellow) wire to
a live terminal. If your unit
is
for use
on
less than
150
volts,
it
has a plug that looks like Fig.
"A".
It
it
is
for ure on
150-250
volts, it has a plug that
looks
like Fig.
"D".
An adapter, Fig. "B" and
"C'
is
available for connecting Fig.
"A'
plugs to two-prong receptacles,
(see Note). The green-colored rigid ear, lug, etc., extending from the adapter must be connected to
a permanent ground such as to properly grounded outlet box.
No adapter
is
available for Fig.
"D"
plugs.
\
Grounding Blade
Cover' of Grounded Outlet Box
FIG.
D
NOTE: THE GROUNDING ADAP-
TER
IS
PROHIBITED IN CANADA
PER
CANADIAN ELECTRICAL
INSTRUCTIONS FOR ITS USE ARE
NOT APPLICABLE IN CANADA.
CODE-PART
1.
THEREFORE, THE
Grounding Blade
EXTENSION
CORDS:
Use
only three-wire extension cords which have three-prong grounding-type
plugs and three-pole receptacles which accept the tool's plug.
Replace or repair damaged or worn
:ord immediately.
3