Filter
Top Products
7
Stopper plate
The stopper plate prevents the cut-off wheel from contacting
the workbench or floor. When a new wheel is installed, set
the stopper plate to position (A). When the wheel wears
down to the extent that the lower portion of the workpiece is
left uncut, set the stopper plate to position (B) to allow
increased cutting capacity with a worn down wheel.
Interval between vise and guide plate
The original spacing or interval between the vise and the
guide plate is 0 - 170 mm (0 - 6-11/16”). If your work requires
wider spacing or interval, proceed as follows to change the
spacing or interval.
Remove the two hex bolts which secure the guide plate.
Move the guide plate as shown in the figure and secure it
using the hex bolts. The following interval settings are possi-
ble:
35 - 205 mm (1-3/8” - 8-1/16”)
70 - 240 mm (2-3/4” - 9-7/16”)
CAUTION:
• Remember that narrow workpieces may not be secured
safely when using the two, wider interval settings.
Setting for desired cutting angle
To change the cutting angle, loosen the two hex bolts which
secure the guide plate. Move the guide plate to the desired
angle (0° - 45°) and tighten the hex bolts securely.
CAUTION:
• Never perform miter cuts when the guide plate is set at
the 35 - 205 mm (1-3/8” - 8-1/16”) or 70 - 240 mm
(2-3/4” - 9-7/16”) position.
1. Stopper plate
1
(A)
(B)
003757
1. Socket wrench
2. Guide plate
3. Move
4. Hex bolts
1
2
3
4
003758
003759
1. Socket wrench
2. Guide plate
3. Hex bolts
1
2
3
003760