Filter
Top Products
9
When the cut-off wheel has worn down considerably, use a
spacer block of sturdy, non-flammable material behind the
workpiece as shown in the figure. You can more efficiently
utilize the worn wheel by using the mid point on the periphery
of the wheel to cut the workpiece.
When cutting workpieces over 65 mm (2-9/16”) wide at an
angle, attach a straight piece of wood (spacer) over 190 mm
(7-1/2”) long x 45 mm (1-3/4”) wide to the guide plate as
shown in the figure. Attach this spacer with screws through
the holes in the guide plate.
If you use a spacer block which is slightly narrower than the
workpiece as shown in the figure, you can also utilize the
wheel economically.
Long workpieces must be supported by blocks of non-flam-
mable material on either side so that it will be level with the
base top.
1. Spacer block
1
003764
1. Guide plate
2. Straight piece of wood (Spacer)
3. Over 45 mm (1-3/4”) long
4. Over 65 mm (2-9/16”) long
5. Over 190 mm (7-1/2”) long
1
2
3
4
5
003765
1. Diameter of workpiece
2. Guide plate
3. Spacer block
4. Width of spacer block
5. Vise
1
2
3
4
5
003766
1. Blocks
1
003767