Filter
Top Products
6
Templet guide (optional accessory)
005045
The templet guide provides a sleeve through which the
bit passes, allowing use of the tool with templet patterns.
To install the templet guide, screw the templet guide on
the base plate.
1
2
005046
1
2
3
4
5
6
7
003695
NOTE:
• The workpiece will be cut a slightly different size
from the templet. Allow for the distance (X)
between the bit and the outside of the templet
guide. The distance (X) can be calculated by using
the following equation:
Distance (X) = (outside diameter of the templet
guide - bit diameter) / 2
Trimmer guide (optional accessory)
005047
Trimming, curved cuts in veneers for furniture and the
like can be done easily with the trimmer guide. The
guide roller rides the curve and assures a fine cut.
Install the trimmer guide on the tool base with the wing
bolts (B). Loosen the wing bolt (A) and adjust the
distance between the bit and the trimmer guide by
turning the fine adjusting screw (1.5 mm or about 1/16"
per turn). At the desired distance, tighten the wing bolt
(A) to secure the trimmer guide in place. When adjusting
the guide roller up or down, loosen the wing bolt (C).
After adjusting it, tighten the wing bolt (C) securely.
1
2
3
4
5
6
005048
When cutting, move the tool with the guide roller riding
the side of the workpiece.
3
1
2
003701
1. Bit
2. Guide roller
3. Workpiece
1. Wing bolt (B)
2. Fine adjusting
screw
3. Wing bolt (A)
4. Trimmer guide
5. Wing bolt (C)
6. Guide roller
1. Bit
2. Base
3. Templet
4. Workpiece
5. Distance (X)
6. Outside
diameter of the
templet guide
7. Templet guide
1. Base plate
2. Templet guide