Filter
Top Products
Hex wrench storage
When not in use, the hex wrench can be
conveniently stored.
Hex wrench
4b
Adjusting the depth
of
cut
Loosen the screw on the depth guide and move the base up or down. You can read the
depth of cut by aligning the top of the notch in the depth guide with the graduations on its
right side. (Note: This can be done for
0"
bevel cutting only.) At the desired depth
of
cut,
secure the base by tightening the screw.
Depth
auide
CAUTION:
*Use
a
shallow depth
of
cut when cutting thin workpiece for cleaner, safer cuts.
*After adjusting the depth of cut, always tighten the clamp screw securely.
Bevel
cutting
Loosen the screw on the bevel scale plate
on the front of the base. Set for the desired
angle
(0"
-
45")
by tilting accordingly, then
tighten the clamp screw securely.
CAUTION:
After adjusting the depth of cut and bevel cutting angle, be sure
to
tighten the screw.