Filter
Top Products
MAINTENANCE
CAUTION
:
Always be sure that the tool
is
switched off and unplugged before attempting to perform
inspection or maintenance.
Cleaning
the
clamp on
the
blade holder
If
chips or foreign matter
get
into the clamp on the blade holder, clean out the clamp
after removing
it
from the blade holder. To remove the clamp, rotate the blade installing
lever (for 4304T) or knob (for 4305T) in the blade loosening direction
as
far
as
it
will go.
Then remove
the
clamp from
the
blade holder while rotating the clamp counterclock-
wise. To install the clamp, first make sure that the blade installing lever (for 4304T) or
knob (for 4305T) has been rotated in the blade loosening direction
as
far
as
possible.
Insert the clamp into the blade holder while rotating
it
clockwise one quarter to one full
turn. Grasp the clamp with your fingers
so
that
it
will not turn, then rotate
the
blade
installing lever or knob in the blade tightening direction
so
that the clamp will go into the
blade holder.
Blade
holder
Clamp
5-
To maintain product SAFETY and RELIABILITY, repairs, any other maintenance or
adjustment should be performed by Makita Authorized or Factory Service Centers,
always using Makita replacement parts.
12