Filter
Top Products
For 4305T
1.
Press the button to raise the blade installing knob.
2.
Rotate the blade installing knob in the
0
direction and the clamp on the blade holder
will open. Open the clamp
a little
more than the thickness of the blade to be installed.
3. With the blade teeth facing forward, insert the blade into the blade holder
as
far
as
it
will go. Make sure that the back edge of the blade
fits
properly into the groove of the
roller.
direction to tighten the clamp.
4. With the blade held against the blade holder, rotate the blade installing knob in the
@
Position Cutting action
Blade installing knob
Button
Applications
t
Blade
Straight
line
cutting
action
0
Blade holder
Roller
For cutting mild steel, stainless steel and plastics.
For clean cuts
in
wood and plywood.
5.
With the blade installing knob kept in this position, push
it
back down to
its
original
NOTE
:
Occasionally lubricate the roller.
posit
ion.
I
II
111
Selecting the cutting action
This tool can be operated with an orbital
or
a
straight line cutting action. To change
the cutting action, just turn the lever to the
desired cutting action position. Refer to
the table below to help determine the
appropriate cutting action.
Small orbit cutting action
For cutting mild steel, aluminum and hard wood.
Medium
orbit
cutting
action
For cutting wood and plywood.
For fast cutting
in
aluminum and mild steel.
For fast cutting
in
wood and plywood.
Large orbit cutting action
6