Filter
Top Products
8
Hex wrench storage
When not in use, store the hex wrench as shown in the figure
to keep it from being lost.
Adjusting roller
Loosen the bolt on the back of the base with the hex wrench.
Move the retainer so that the roller contacts the blade lightly.
Then tighten the bolt to secure the base and the retainer.
NOTE:
• Occasionally lubricate the roller.
Dust cover
CAUTION:
• Always wear safety goggles even when operating the
tool with the dust cover lowered.
Lower the dust cover to prevent chips from flying. However,
when making bevel cuts, raise it all the way.
Anti-splintering device (optional accessory)
For splinter-free cuts, the anti-splintering device can be used.
To install the anti-splintering device, move the base all the
way forward and insert it between the two protrusions of the
base.
NOTE:
• The anti-splintering device cannot be used when making
bevel cuts.
1. Hook
2. Hex wrench
1
2
002727
1. Retainer
2. Blade
3. Roller
4. Base
5. Bolt
6. Hex wrench
1
2
3
4
5
6
002728
1. Dust cover
1
002729
1. Anti-splintering device
2. Protrusions
1
2
002731