Filter
Top Products
7
Keeping that situation, insert the saw blade into the blade clamp as far as the
two protrusions of the blade can not be seen.
Return the tool opener to its original position.
After installing, always make sure that the blade is securely held in place by
trying to pull it out.
CAUTION:
• Do not open the tool opener excessively, or it may cause tool damage.
To remove the blade, open the tool opener to the position shown in the figure.
Pull the saw blade out toward the base.
NOTE:
• Occasionally lubricate the roller.
Hex wrench storage
When not in use, the hex wrench can be conveniently stored.
OPERATION
CAUTION:
• Always hold the tool base flush with the workpiece. Failure to do so may
cause blade breakage, resulting in a serious injury.
Turn the tool on and wait until the blade attains full speed. Then rest the tool
base flat on the workpiece and gently move the tool forward along the previ-
ously marked cutting line. When cutting curves, advance the tool very slowly.
1. Blade clamp
2. Jig saw blade
3. Protrusions
1
2
3
001910
1. Jig saw blade
1
001911
1. Base
2. Hex wrench
1
2
001912
1. Cutting line
2. Base
1
2
001913