Filter
Top Products
15.
Place the wider portion of the saw base on that part of the workpiece which
is
solidly supported, not on the section that
will
fall off when the cut is made.
As
examples, Fig.
5
illustrates the RIGHT way to cut off the end of a board,
and Fig.
6
the WRONG way. If the workpiece
is
short or small, clamp
it
down.
DON'T TRY TO HOLD SHORT
PIECES
BY
HAND!
Fig.
5
Fig.
1
r------
16.
Never attempt to saw
with
the circu-
lar saw held upside down
in
a vise.
This
is
extremely dangerous and can
lead to serious accidents.
I
Fig.
17.
Before setting the tool down after completing a cut, be sure that the lower
(telescoping) guard has closed and the blade has come to a complete stop.
SAVE THESE INSTRUCTIONS.
8