Filter
Top Products
12
Adjusting depth of cut
CAUTION:
• After adjusting the depth of cut, always tighten the
clamping screw securely.
Loosen the clamping screw on the depth guide and move the
base up or down. You can read the depth of cut by aligning
the top of the notch in the depth guide with the graduations
on its right side. (Note: This can be done for 0°bevel cutting
only.) At the desired depth of cut, secure the base by tighten-
ing the clamping screw.
For cleaner, safer cuts, set cut depth so that no more than
one blade tooth projects below workpiece. Using proper cut
depth helps to reduce potential for dangerous KICKBACKS
which can cause personal injury.
Bevel cutting
Loosen the clamping screw on the bevel scale plate on the
front of the base. Set for the desired angle (0° - 45°) by tilting
accordingly, then tighten the clamping screw securely.
Sighting
For straight cuts, align the A position on the front of the base
with your cutting line. For 45° bevel cuts, align the B position
with it.
1. Depth guide
2. Base
3. Top of notch
4. Graduation
5. Clamping screw
1
2
5
4
3
001350
1. Clamping screw
2. Bevel scale plate
2
1
001367
1. Base
2. Cutting line
B
2
A
1
001385